CE marked · ISO 9001:2015 · 18-month warranty

Technical notes · · 6 min read

Strand, water ring or underwater: which cutting method

Pellet shape, floor space, dust level, polymer suitability and price — the same comparison we run with every buyer.

Water ring pelletizer used to compare strand, water ring and underwater cutting

Strand cutting gives cubic pellets and a visible melt, and needs 8–12 m of length. Water ring cuts at the die face inside a ring of water and needs 5–7 m. Underwater cuts in a pressurised chamber and needs 6–8 m but produces the roundest, cleanest pellet. The right choice is decided by the pellet your customer buys.

Criterion Strand Water ring Underwater
Pellet shape Cubic, sharp edges Rounded Spherical
Floor length 8–12 m 5–7 m 6–8 m
Fines level 0.5–1.5% 0.3–0.8% below 0.2%
Best polymers PP, PE, ABS, PVC PP, PE, filled PP PET, PA, masterbatch
Operator attention High (strand breaks) Medium Low
Relative price 1.0 1.3 1.8

Why PET cannot run on a strand line

Amorphous PET crystallises on the surface as it cools in air, so a strand becomes brittle and snaps at the first guide roll. Underwater cutting quenches the pellet in milliseconds, keeping the surface amorphous and the pellet ductile. The same logic applies to PA, which absorbs moisture from the air bath within seconds.

A note on pellet shape and feeding

Cubic pellets from strand cutting feed more predictably in injection machines because they interlock less; round pellets flow better in pneumatic conveying and cause fewer bridging problems in silos. If your customer complains about hopper bridging, round is better; if they complain about feed-zone surging, cubic is better.

Questions buyers ask

Can I change cutting method later?

On the same extruder frame, yes — water ring and strand share the die flange, so a swap is a mechanical change plus a control parameter. Underwater needs a different chamber and dryer, so it is better decided at order stage.

Which is best for filled PP with 40% CaCO3?

Water ring. The filled melt is abrasive and sets fast; die-face cutting in a ring avoids the strand breakage you would get in a bath, and the round pellet conveys well in a dosing system.

Keep reading

Technical notes

العربيةAR