CE marked · ISO 9001:2015 · 18-month warranty

Equipment index · 6 output and feedstock terms

Plastic pellets, granules, flakes and regrind

Buyers and engineers use these six words for four different stages of the same material. Agreeing on them prevents a specification that nobody can quote against.

6 defined terms on this page, each with its own citable definition.

Terminology

Finished product terms

When a buyer asks for pellets, the numbers that matter are melt flow index, bulk density, pellet size distribution, moisture, colour and contamination — in that order.

Plastic pellets

塑料颗粒

Melt-filtered, uniformly cut granules, usually 2–4 mm. Strand cutting gives cubic pellets, water ring and underwater cutting give rounded ones.

See the matching machine

Plastic granules

塑料粒子

Interchangeable with plastic pellets in most markets. The TL-GPL plastic granules production line takes bales through to bagged granules at 500–3,000 kg/h.

See the matching machine

Recycled plastic pellets

再生塑料颗粒

Pellets made from waste feedstock. The resale price depends on melt flow consistency, odour, colour and how low the filtration kept the gel count.

See the matching machine

Terminology

Feedstock and in-process terms

These describe material before it becomes a pellet. Confusing them with finished output is the most common reason two quotations disagree by a factor of two.

Plastic flakes

塑料碎片、瓶片

Washed 25–30 mm fragments from a crusher. For PET they are separated by density in a floating and sinking tank before drying and extrusion.

See the matching machine

Plastic scraps

边角料 / 废料

Loose production waste: sprues, edge trim, rejected mouldings, sheet offcuts. Clean in-house scrap can go straight to a crusher and a pellet mill.

See the matching machine

Regrind material

再生料 / 回料

Scrap that has already been ground to a usable size. It can be blended back into a moulding process or pelletized for more consistent dosing.

See the matching machine

Questions

What buyers ask next

Each answer is written to stand on its own when quoted.

How should I specify recycled plastic pellets to a buyer?

State the base polymer, melt flow index with test condition, ash or filler content, moisture, pellet size range, colour, odour, contamination or gel count, and the intended application. A pellet sold for pipe extrusion and one sold for injection moulding are different products even when both are labelled HDPE.

Why do your output figures differ from a competitor with the same screw diameter?

Because our figure is finished bagged pellets averaged over a four-hour run on a named material, while screw throughput or incoming flake weight can be 20–30% higher. Ask any supplier what exactly the kg/h measures and on which feedstock.

Continue

Related machines and equipment indexes

Follow the equipment chain, or open the machine pages for specifications and price ranges.

Next step

Not sure which term fits? Describe the material instead

Polymer, form, contamination, target output, voltage and country are enough for a model recommendation within one working day.

Tell us what you need to granulate

Six fields is enough for a first recommendation. Drawings, layout and a firm price follow after the material sample is tested.

Used only to answer this enquiry. No lists, no resale.

العربيةAR