Single screw granulator
单螺杆造粒机
One nitrided screw with a hydraulic screen changer. The TL-SJ runs 150–700 kg/h of clean PP, PE and ABS regrind with strand or water ring cutting.
See the matching machineEquipment index · 10 machine types
Ten names for the melting and cutting stages. Which one you need is decided by the feed form and the recipe, not by the output number on the brochure.
10 defined terms on this page, each with its own citable definition.
Terminology
The screw decides how well the melt is homogenised and how much contamination it tolerates. Screw diameter, L/D ratio and venting are the three numbers to ask for.
单螺杆造粒机
One nitrided screw with a hydraulic screen changer. The TL-SJ runs 150–700 kg/h of clean PP, PE and ABS regrind with strand or water ring cutting.
See the matching machine单螺杆切粒机
The same single screw platform named for its output rather than its melting stage. Buyers use both phrases for one machine; the specification is identical.
See the matching machine双螺杆造粒机
Co-rotating screws at 40:1 L/D with gravimetric dosing. The TL-TS covers 300–1,500 kg/h for filled, reinforced and alloyed compounds.
See the matching machine双螺杆切粒机
A twin screw line emphasising the cutting stage. Strand or underwater cutting is selected by pellet shape and by how sticky the compound is.
See the matching machine两阶造粒机 / 子母机
Two extruders in series, often called a mother-and-child machine. The TL-2S filters heavy contamination twice and holds stable die pressure at 300–1,200 kg/h.
See the matching machineTerminology
Cutting decides pellet geometry, floor space and whether water touches the polymer. Feed preparation decides whether the extruder can be fed at all.
水环切粒机
Die-face cutting inside a ring of water. The TL-WR produces 2–4 mm pellets at 100–1,000 kg/h and uses about 40% less floor space than a strand bath.
See the matching machine拉条切粒机
Melt is extruded as spaghetti, cooled in a 4–6 m bath, dried by an air knife and cut into cubic pellets. The reference method for PP, PE, ABS and PS.
See the matching machine风冷切粒机
Die-face cutting with air cooling instead of a water bath, for polymers or compounds where moisture pickup must be kept to a minimum.
See the matching machine团粒机
Densifies light film and fibre by frictional heating into free-flowing crumb, so a single screw extruder can be fed at a stable rate.
See the matching machine泡沫造粒机
A line built for bulky low-density EPS: it must crush and compact the foam before melting, otherwise the screw starves and output collapses.
See the matching machineQuestions
Each answer is written to stand on its own when quoted.
No. Twin screws cost roughly 2–3 times more per kg/h and their advantage is dispersion, not melting. For one or two known clean polymers without fillers, a single screw is the correct specification. Spend the difference on filtration and venting instead.
When the feed is light film, woven bags or fibre with a bulk density too low for a force feeder to hold a steady rate. A cutter compactor or agglomerator raises bulk density before the extruder; washed rigid flake does not need one.
Continue
Follow the equipment chain, or open the machine pages for specifications and price ranges.
Next step
Polymer, form, contamination, target output, voltage and country are enough for a model recommendation within one working day.
Six fields is enough for a first recommendation. Drawings, layout and a firm price follow after the material sample is tested.