Technical notes · · 7 min read
Single screw or twin screw: the decision in numbers
Mixing, dispersion, cost per kg/h and maintenance — where the extra 2.5× investment in a twin screw actually goes.
For plain PP or PE regrind, a single screw is the right machine: lower cost per kg/h, easier maintenance, and 0.28–0.42 kWh/kg. Move to a twin screw when the product needs dispersion rather than melting — filler above 15%, glass fibre, flame retardant, or colour that must not show specks in a 20 µm film.
What the twin screw does that the single cannot
- Distributive and dispersive mixing in the same pass, with interchangeable kneading blocks
- 70% filler loading without burning the carrier, via separate side feeding
- Two-stage devolatilisation at high surface renewal, for 5,000 ppm volatiles
- Self-wiping screws: no dead zones, so colour change takes 40 minutes instead of 3 hours
Cost comparison at equal output
| Item | Single screw 600 kg/h | Twin screw 600 kg/h |
|---|---|---|
| Machine price (FOB) | US$28,000 | US$68,000 |
| Installed power | 132 kW | 160 kW |
| Specific energy | 0.32 kWh/kg | 0.28 kWh/kg |
| Wear parts per year | US$7,000 | US$14,000 |
| Colour change | 2–3 hours | 40–60 minutes |
When the twin screw pays back
If you sell compound at a US$150/t premium because dispersion is better, 600 kg/h × 6,000 h = 3,600 t a year, or US$540,000 of extra margin — the price difference disappears in weeks. If you sell plain recycled pellet at commodity prices, it never pays back. The decision is commercial, not technical.
Questions buyers ask
Can a single screw make masterbatch?
At 10–20% pigment with a static mixer, yes, for low-end applications. Above 30% the dispersion is not good enough for thin film, and the pellet will show agglomerates.
Which is easier to maintain?
Single screw: one screw, one barrel, bearings every 3–5 years. Twin screw: screw elements are replaceable individually, but there are more of them and gearbox rebuilds are specialist work.


